Xantech Switch 282TP User Manual

MODEL

282TP

Mouse Emitter, Twin Plug

INSTALLATION INSTRUCTIONS

DESCRIPTION

The 282TP "Twin-Plug" Emitter is based on Xantech's

standard 282M Mouse emitter with two 3.5mm Mono-

Mini plugs each with 'diode' isolation. The twin plug feature

allows a single emitter to be shared by two IR sources. For

instance, one mouse emitter can now be connected to both

an IR receiver and a Xantech Multi-Zone Controller without

having to place two emitters on the front of the IR

Controllable component.

Internally, the 282TP contains components that are

designed to keep the IR signal path directed towards the

emitter only, allowing both control systems to be completely

isolated. The plugs are gold plated to increase durability

and connectivity.

INSTALLATION

•

Each emitter has a clear adhesive layer on the bottom

flat surface of the shell. The rounded side faces the

user and emits visible light when a command is sent.

Simply peel off the adhesive cover and affix the emitter

to the center of the IR sensor window on the controlled

component’s front panel.

•

In some cases it may be difficult to find the location of

the IR sensor on the component. Consult the owner’s

manual of the unit, or the manufacturer, for the exact IR

sensor window location.

Double-sided adhesive tape is included. If you move the

emitter to a different component, use this tape to

replace the current adhesive layer for the best

adhesion.

•

The shell, though dark in appearance, is transparent to

infrared light, allowing commands from a handheld

remote control to pass through it. This permits direct

control of the equipment from a handheld remote as

well as from the 282TP.

13100 Telfair Ave. 2/F

Sylmar, CA 91342