Instruction Sheet
Model D3244
Heavy Duty Wagon
INTRODUCTION
The SHOP FOX® Model D3244 Heavy Duty
Wagon makes hauling cargo a breeze with its
high wooden sides.
Check the inventory list below Figure 1 to
ensure all the parts are present. All fasteners
require a hex nut, lock washer and flat
washer.
To assemble the Model D3244, do these steps:
1. Turn the wagon bed upside down and
attach the rear axle and axle braces with
the M6-1 x 16 flat head screws.
Figure 1. Wagon fully assembled.
INVENTORY LIST
2. Attach the steering assembly pieces with
the M10-1.5 x 20 carriage bolt, then insert
the cotter pin.
• (1) Wagon Bed
• (1) Handle
• (4) Tires
• (2) Steering Assembly
• (4) Long Wooden Panels
• (1) Rear Axle Assembly
• (2) Rear Axle Braces
• Hardware Bag 1
3. Secure the steering assembly to the
underside of the wagon bed with the M6-1
x 16 flat head screws.
4. Install the wheels on the axles with the air
valves and cotter pins facing out, and
secure the axle caps.
(1)
Button Head Screw M6-1 x 75
Cotter Pins
(5)
(1)
(1)
(1)
Special Carriage Bolt M10-1.5 x 20
Hex Nut M10-1.5
Flat Washer 12mm
5. Attach the handle to the steering assembly
with the M6-1 x 75 button head screw.
(1)
(4)
Lock Washer 10mm
Flat Washers 16mm
Hex Nuts M6-1
6. Attach the wooden side panels with the
M6-1 x 45mm button head screws in this
order: 1) Left side panel 2) rear panel 3)
right side panel and 4) front panel.
(19)
(19)
(19)
(8)
(10)
(4)
Flat Washers 6mm
Lock Washers 6mm
Flat Head Screws M6-1 x 16
Button Head Screws M6-1 x 45
Axle Caps
CAUTION—ADULT SUPERVISION IS REQUIRED
AT ALL TIMES WHEN USING THIS WAGON.
COPYRIGHT © BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS DOCUMENT MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
NOVEMBER 2003, PRINTED IN CHINA.
|